Dryer Vent Cleaning technician working in King City
King City · 24 HOUR RESPONSE GUARANTEED

Dryer Vent Repair King City — Ducts, Hoods & Re-Routes

Screws through a duct interior catch lint like a comb. It is the most common bad-install detail we find.

4.9 average from 743 verified GTA customers
24 hour response
Licensed & insured
Written photo report

Free dryer fire-risk score + $40 off a booked cleaning

Free dryer vent fire-risk score

Seven questions, about 40 seconds. Built from what our technicians actually find in King City homes.

1. When was your dryer vent last professionally cleaned?
2. How long does a normal load take to dry?
3. Roughly how long is the duct run to the outside?
4. What is the duct behind the dryer made of?
5. Do you notice any of these while the dryer runs?
6. How many loads does your household run per week?
7. When did you last look at the exterior vent hood?

Cleaning only helps if the duct is intact. We replace crushed foil with rigid or semi-rigid metal, reseal joints that came apart inside a joist bay, re-route runs that were never compliant, and replace exterior hoods that no longer close in King City.

Common failures we replace

Torn or collapsed flex behind the appliance, ducts terminating into an attic or soffit, screw penetrations catching lint, unsealed joints leaking into framing, and broken hood dampers.

Rigid metal, foil-taped joints

Concealed runs get smooth rigid metal with foil-taped joints and no interior fasteners. That is both the code requirement in King City and the reason the duct stays clear longer.

Re-routing that actually works

Too many elbows or an uphill run guarantees repeat blockages. Where the route is the problem, we redesign it rather than cleaning the same failure every year.

Dryer Vent Cleaning pricing in King City

Real 2026 ranges. Your exact number is confirmed in writing before any work starts.

ServiceTypical range
Transition replacement (behind dryer)$120 – $240
Exterior hood and damper replacement$189 – $340
Joint repair and duct resealing$180 – $420
Full duct re-route$650 – $2,400

How the visit works in King City

  1. 1

    Airflow test before we start

    We measure real exhaust airflow at the exterior hood so you see the honest 'before' number for your home in King City.

  2. 2

    Camera scan of the duct

    A push camera runs the elbows, transitions, and termination so the blockage is located, not guessed at.

  3. 3

    Rotary brush and HEPA vacuum

    A counter-rotating brush breaks the lint mat loose while a negative-pressure HEPA vacuum captures it. Nothing blows back into the laundry room.

  4. 4

    Termination and damper service

    Exterior hood cleared, damper flap freed, and bird nests or lint-catching screens removed.

  5. 5

    Transition and connection check

    Crushed foil behind the dryer is straightened or replaced with rigid or semi-rigid metal and properly clamped.

  6. 6

    After test and photo report

    We re-measure airflow and email before/after numbers with photos, so the improvement is documented rather than promised.

What King City customers say

4.9 out of 5 from 743 reviews across the GTA. A selection relevant to this service below.

Condo stack, no fuss
Stacked unit in a tiny closet. They pulled it, fitted a proper periscope, cleaned the run, and put everything back exactly as it was.
Elena V.Vaughan · December 2025
Thermal fuse kept blowing
Appliance tech had replaced the fuse twice. Diamond found the actual blockage. No failures since.
Victor S.North York · November 2025
Bird nest in the vent hood
Removed the nest, fitted a proper damper, and explained why the old screened hood was the reason it kept happening.
Diane W.Oakville · February 2026
Straight pricing
Quoted a range on the phone, confirmed the exact number after seeing the run, and stuck to it.
Luis M.Oshawa · May 2026

Dryer Vent Cleaning FAQs — King City

Can you repair without opening walls?

In most homes in King City, yes — we work from the appliance side and the exterior termination, and tell you upfront if access is unavoidable.

How do I know the duct is leaking?

Humidity or a warm-lint smell in the laundry room while the dryer runs, or lint dust on nearby surfaces.

Is foil flex duct allowed at all?

Only as a short, exposed transition behind the appliance — never inside a wall, floor, or ceiling.

Do you handle townhouse and condo runs?

Yes, including shared shafts, booster fans, and the documentation building management asks for.

How long does a repair take?

Transitions and hoods take an hour or two. Re-routes are usually a half or full day.

Is the work warrantied?

Yes — a written workmanship warranty on all repairs in King City.

Book dryer vent cleaning in King City

Free dryer fire-risk score + $40 off a booked cleaning24 hour response guaranteed.

Call (437) 475-2233