Diamond Home Services logo
Diamond Home ServicesServing Toronto & the GTA
24 HOUR RESPONSE GUARANTEED

Dryer Vent Repair in Bayview Wellington, Aurora

Dryer vent repair in Bayview Wellington, Aurora — crushed ducts, disconnected joints, and failed hoods fixed properly.

Call (437) 475-2233Request a quote
24 hour response
Licensed & insured
OEM parts on the truck

Cleaning only helps if the duct itself is intact. Our dryer vent repair crews in Bayview Wellington, Aurora replace crushed flexible duct with rigid or semi-rigid metal, reseal disconnected joints, re-route runs that were never code-compliant, and replace exterior hoods that no longer close. If your laundry room gets humid or you can smell warm lint while the dryer runs, the duct is leaking somewhere inside the house.

Why dryer vent repair matters in Bayview Wellington, Aurora

Plastic And Foil Duct Is A Hazard

Vinyl and thin foil flex duct sag, tear, and burn. Code in Bayview Wellington, Aurora calls for smooth rigid metal on concealed runs, and that is what we install.

Leaks Are Invisible Until Damage Shows

A duct that came apart inside a joist bay vents hot, wet air into insulation for months before a stain or mould smell appears.

Bad Routing Never Dries Properly

Too many elbows, an uphill run, or a termination into a soffit guarantees repeat blockages. We fix the route, not just the symptom.

Our dryer vent repair process

  1. 1

    Airflow Test First

    We measure actual exhaust airflow at the exterior hood before touching anything, so you see the real 'before' number for your home in Bayview Wellington, Aurora.

  2. 2

    Camera Inspection

    A push camera runs the full duct line — elbows, transitions, and the wall or roof termination — showing exactly where lint has packed in.

  3. 3

    Rotary Brush + HEPA Vacuum

    A counter-rotating brush breaks the lint mat loose while a negative-pressure HEPA vacuum captures it. Nothing blows back into your laundry room.

  4. 4

    Termination & Hood Service

    We clear the exterior hood, free the damper flap, and remove bird nests or screens that trap lint.

  5. 5

    After Test & Report

    We re-measure airflow and email a before/after report with photos so the improvement is documented, not just promised.

Common findings in Bayview Wellington, Aurora

  • Torn or collapsed flexible duct behind the appliance
  • Duct terminating into an attic, soffit, or crawlspace
  • Screws penetrating the duct interior and catching lint
  • Unsealed joints leaking hot moist air into framing
  • Broken or missing exterior hood dampers

What you get

Shorter Dry Times

Most homes in Bayview Wellington, Aurora go from two or three cycles back to a single 40-minute cycle — an immediate hydro saving.

Real Fire Risk Reduction

Lint is the leading ignition source in dryer fires. Clearing the duct removes the fuel.

Documented, Warrantied Work

Written airflow numbers, photos, and a workmanship warranty on every visit.

FAQ

Can you replace the duct without opening walls?

In most homes in Bayview Wellington, Aurora, yes — we work from the appliance side and the exterior termination. We tell you upfront if access is required.

What does a repair cost?

Simple transition and hood replacements start around $189. Full re-routes are quoted after inspection, always in writing.

Do you handle condo and townhouse runs?

Yes, including shared-shaft buildings, booster fans, and property-management documentation.

Book your dryer vent repair today

24 HOUR RESPONSE GUARANTEED — call now to lock in a slot in Bayview Wellington, Aurora.

Call (437) 475-2233

More Aurora services

Related pages

Dryer Vent Repair in other Aurora neighborhoods